Heat Transfer Printing Felt Installation Guide Factory Suppliers Manufacturers Quotes

Heat Transfer Printing Felt Installation Guide

Heat Transfer Printing Felt Installation Guide

 

1. The blanket must be install  as the direction of the arrow, fixing both sides of the perimeter to see if the perimeter is the same.

2. Adjust the machine pressure within 2kg. heat up to 150 ℃, idle for 2 hours; heat up to 170℃, idle for 2 hours; heat up to 190℃, idle 3 hours( important); heat up to 200℃, idle for 2 hours.  

Then the belt will suitable for your machine, you can adjust the machine pressure in 3--5kg    according to your needed and start to printing.       


Once you have other problem, kindly contact us to ask for the solutions.


Please feel free to give your inquiry in the form below. We will reply you in 24 hours.