Common problems of pasting belt using(with solution) Factory Suppliers Manufacturers Quotes

Common problems of pasting belt using(with solution)

Common problems of pasting belt using(with solution):


1. The belt was scratched when the machine was running.-- please check if there is any debris in the belt or in the lead paste. (please make sure that there is no debris on the tape.)

2. The belt slippage when the machine was running,-- please make sure that the tape is fully wet with warm water before the machine and properly adjust the elastic shaft.

3. When the machine is running, the tape is stuck.-- kindly make sure the belt thickness is suitable for your machine, and proper adjustment of the scraper height can alleviate the problem.

4. The belt is too hard to get on machine.--- steam it for about 5 minutes.

5. The belt is not smooth after installing to machine. --- Before using,the belt must be soaked with warm water to make the belt soft and avoid the crease of packing effect your usage.


Once you have other problem, kindly contact us to give you the solutions.


Please feel free to give your inquiry in the form below. We will reply you in 24 hours.